1.It can load the battery under-voltage fault function.
2. Foslink wireless communication technology is used, without wiring.
3. Only an ID is built in, and it is connected to the wireless transmission module and the fire alarm controller network.
4. The PCB is fully sealed.
1. It can load the battery under-voltage fault function.
2. Foslink wireless communication technology is used, without wiring.
3. Only an ID is built in, and it is connected to the wireless transmission module and fire alarm controller network.
4. The PCB is fully sealed.
| Listed | LPCB Pending |
| Compliance | EN54-3 |
| Power Rating | |
| Input Voltage | Loop Power: 24VDC [18V to 27.5V] |
| External PSU | 24VDC [20V to 27.5V] |
| Typical Current | Loop: Standby 0.6mA, Alarm: 1.5mA |
| Loop and External PSU |
Standby 0.6mA, Alarm: 10mA |
| Saving Current | Standby 1.2mA, Alarm: 4mA |
| Sounder | 2 Circuit: Normally Open/ Close dry contact |
| Protocol/ Addressing | T&A, Value range from 1 to 254 |
| Address Sequence | Single Address: Evacuate tone |
| Dual Address | 1st Alert Tone / 2nd Evacuate tone |
| Material / Colour | ABS / RED Glossy finishing |
| Dimension / Height | Diameter 110 mm / 39.6 (with Base) |
| Weight | 180g (with Base), 114g (without Base) |
| Class | Type A, Indoors |
| Operating Temperature | -10°C to +50°C |
| Ingress Protection Rating | IP21 |
| Humidity | 0 to 95% Relative Humidity, Non condensing |
